Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Provo?
Chimney liner and rebuild work in Provo typically runs from about $1,200 for a straightforward stainless-steel liner to $9,500 or more for a full chimney rebuild with a new crown and exterior masonry. Most Provo homeowners who call us fall somewhere in the middle: a relined flue or a repaired smoke chamber in the $2,400 to $4,800 range. Liners and rebuilds sit at opposite ends of chimney work, so the first thing we do is inspect the flue and tell you which one you actually need.
A liner protects the flue from the fire inside it. A rebuild restores the chimney structure that holds that flue upright. One is an interior job, the other reaches the crown and the masonry above the roofline. Because the two are priced so differently, a written estimate that separates them is the only way to compare bids fairly. Our estimates are free, our technicians have up to 15 years of experience, and we’re licensed and insured.
Key takeaways:
- A stainless-steel liner for a typical Provo flue usually costs $1,200 to $3,600.
- HeatShield ceramic resurfacing for cracked mortar joints usually runs $1,400 to $3,200.
- A partial rebuild of the chimney top typically costs $3,000 to $6,500.
- A full rebuild often lands between $6,500 and $9,500 or higher, depending on height and access.
- Everything is priced per job by a free written estimate. Call (855) 340-2065.
Chimney Liner & Rebuild Cost Breakdown (2026)
Here’s how the line items shake out for Provo in 2026. Treat these as typical estimates, not quotes. The written estimate you receive sets the final price.
| Line item | Typical cost | What it covers |
|---|---|---|
| Stainless-steel liner, single flue | $1,200 – $3,600 | DuraFlex liner, insulation, top plate, and termination cap |
| Liner for a tall or offset flue | $2,800 – $5,200 | Extra length, offset handling, and a second story’s worth of routing |
| HeatShield ceramic resurfacing | $1,400 – $3,200 | Repairing cracked or spalling mortar joints in the smoke chamber and flue |
| Smoke chamber parging | $600 – $1,600 | Smoothing the transition above the damper for better draft |
| Crown repair or replacement | $900 – $2,600 | Sealing the top against water, which is the biggest cause of masonry failure here |
| Partial rebuild (top section) | $3,000 – $6,500 | Rebuilding the above-roof masonry and flue tiles |
| Full chimney rebuild | $6,500 – $9,500+ | Tear-out and rebuild of the stack with new flue, crown, and cap |
| Gelco or Famco cap or cover | $250 – $800 | Code-compliant exterior termination, weather-tight |
| Dryer vent cleaning (same visit) | $150 – $350 | Cleaning the dryer duct and confirming it vents safely |
What pushes a Provo liner or rebuild toward the top of these ranges? A very tall stack, a flue with multiple offsets, a chimney tucked close to a roofline that limits ladder access, or a home where the original masonry has taken on years of water intrusion. What pulls it toward the bottom? A single-story ranch with a straight flue and a sound crown. If your chimney already has a cap in good shape, that’s one line item off the estimate.
We install DuraFlex stainless-steel liner systems and use HeatShield ceramic resurfacing for mortar joint damage. Both are industry-grade materials, not hardware-store substitutes. We also source caps and venting components through Olympia Chimney and Copperfield supply networks so the exterior of the system matches the work inside it.
What Affects Chimney Liner & Rebuild Pricing in Provo
A liner or rebuild bid in Provo is shaped by the terrain, the housing, and the season, not just by square footage. Here are the factors that move the number most.
- Chimney height and roofline access. Provo has its share of two-story homes and steeply pitched roofs. The taller the stack or the trickier the roof, the more setup time goes into a rebuild, and that shows up in the price.
- Flue offsets and shape. A straight round flue takes a liner easily. A rectangular flue with a jog in it needs a different approach and more labor. Older Provo homes near downtown often have flues that weren’t lined to begin with, which changes the whole job.
- Cold, dry winters and a long heating season. Provo’s winters run cold and its summers run hot and dry – a wide swing from one season to the next. That swing works masonry hard. Freeze-thaw cycles crack crowns and mortar joints, and dry summer heat pulls moisture out of brick. A rebuild that accounts for this lasts longer than a patch-and-run approach.
- Wood heat and creosote buildup. Many Provo households burn wood regularly through the winter. Heavy creosote in a flue that’s already damaged is a fire hazard, and getting the flue clean enough to inspect and reline is a cleaning job first. That’s part of the estimate.
- Repair versus replace. A cracked flue without structural damage can often be resurfaced instead of rebuilt. That’s the difference between a $1,400 job and a $9,000 job, and it’s why we inspect before we quote.
- Whether the cap and crown are already sound. We install Gelco and Famco caps and venting covers to make the exterior termination weather-tight. If yours is already in good shape, that item drops off the estimate.
The local climate matters to more than just the price of the work. It’s the reason a rebuild isn’t an upgrade but a necessity when the masonry has started failing. Read more about how we approach chimney sweep work across Provo on our chimney sweep service page, or get the full picture of what a full-service visit involves on our Provo service overview.
Liner Repair or Rebuild: Which One Do You Actually Need?
This is the honest question that decides the budget. Most calls we take could go either way on the phone, so we inspect and then recommend. Here’s how the two break down.
When a reline is the right call
A liner question is really a question about the flue interior. If the brick is standing, the crown is sealed, and the flue tiles are cracked or missing, a DuraFlex stainless liner or HeatShield resurfacing fixes the safety problem without touching the structure above the roof. This is the common case in Provo. It’s also the less disruptive job: no scaffolding, no removing masonry from the side of the house, and it comes as a clean inspect-and-repair step in one visit.
When a rebuild is the right call
A rebuild is on the table when the masonry itself has failed. That means spalling brick that’s breaking apart, a chimney that’s leaning, a crown that’s cracked through, or flue tiles that are gone beyond the point of resurfacing. Left unaddressed, a failing chimney lets water into the house, lets hot gases into the framing, and eventually comes down outside the roofline. In that situation, a liner alone is putting new pipe in a weak structure. Our job is to tell you which of these two situations you’re in.
We also install caps and exterior venting components from Gelco and Famco, so the reconstruction of the chimney top is done as a finished piece rather than left open to the weather.
Why Cheap Liner Quotes Cost More Later
A liner isn’t expensive because the stainless is expensive. It’s expensive because the labor and the safety are. A quote that comes in hundreds below the rest usually leaves out insulation, a proper top plate, a cap, or the inspection that confirms the flue is sound before the liner goes in. We’ve seen those shortcuts fail within a few seasons, and the second job costs more than the first one would have. The same applies to rebuilds. A rebuild done with mismatched brick and no weep details will take on water. A rebuild done with a proper crown, a matched cap, and the correct flue sizing will last. That’s the difference we’re selling, and it’s why we don’t quote to win on price.
We work with a curated roster of professional product lines: DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield. Using named products means the estimate says what’s being installed, not just “a liner.” That’s the level of detail you should expect in a written quote.
How to Save on Chimney Liner & Rebuild
There’s no trick to a lower liner price, but there are sensible ways to keep the number honest and keep it from growing.
- Inspect before you commit. Get a written estimate that separates the liner, the crown, and the cap. You’ll see exactly where the money is going and what’s optional.
- Combine the visit. We clean, inspect, and repair in a single visit. Pairing a liner with a sweep keeps you from paying for a second trip. The same goes for a dryer vent cleaning, which we can handle on the same call.
- Fix the crown while the roof is accessible. A crown repair now is a fraction of a partial rebuild later. Water is the primary enemy of masonry in Provo’s climate, and the crown is the first line of defense.
- Schedule before the heating season. Fall and early winter are busy. Getting an inspection in ahead of the first cold snap leaves room to make a repair decision without pressure.
- Ask about the cap. A Gelco or Famco cap keeps rain, snow, and animals out of the flue. A capped chimney lasts longer than an open one.
We offer free estimates, so the inspection costs you nothing but the phone call. Call (855) 340-2065 to schedule. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Does a Chimney Rebuild Require a Permit in Provo?
Assuming the chimney is part of a structure and not a freestanding decorative feature, most Provo projects that involve structural masonry work require a building permit. A liner replacement generally does not. A full rebuild, a chimney height change, or any work that touches the framing usually does. We don’t issue permits and we don’t decide what your city requires – your building department does. What we do is tell you, before the estimate is signed, whether the scope of work is likely to trigger a permit, so you can check with the city and plan for the review. It’s part of the estimate conversation, not an afterthought.
How Long Does a Liner or Rebuild Take?
A typical liner job is a same-day project once the flue is cleaned and inspected. HeatShield resurfacing can often be completed on the same visit too. A rebuild is measured in days, not hours: a partial top rebuild usually runs a couple of days, and a full rebuild takes longer depending on height and access. Since Provo’s winters can shorten the working window on exterior masonry, schedule rebuilds with a margin. We’re happy to lay out the timeline on the estimate so you know what to expect.
FAQs – Chimney Liner & Rebuild Cost
How much does a chimney liner cost in Provo?
A chimney liner in Provo typically costs $1,200 to $3,600 for a standard single flue, and $2,800 to $5,200 for a tall or offset flue. The written estimate sets the final price. Call (855) 340-2065 for an exact quote – estimates are free.
How much does a full chimney rebuild cost in Provo?
A full chimney rebuild in Provo usually runs $6,500 to $9,500 or more, depending on height and access. A partial top rebuild is more often in the $3,000 to $6,500 range. Call (855) 340-2065 to find out which applies to your chimney.
Is it cheaper to reline or rebuild my chimney?
Relining is almost always cheaper, often by thousands of dollars. A liner runs a fraction of a rebuild when the structure itself is sound. The decision comes down to whether the masonry has failed – if it has, a liner alone won’t make the chimney safe. Call (855) 340-2065 for a free inspection and an honest answer.
Can you come today?
In many cases, yes. Same-day service is often available for inspections and liners. We answer 24/7 and dispatch Sunday through Friday, 7am to 7pm. Call (855) 340-2065 to check the schedule.
Do you offer free estimates?
Yes. Every chimney liner and rebuild estimate is free, and the price is set per job by the written estimate. Call (855) 340-2065 to schedule. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Talk to Us Before You Decide
A liner or rebuild is a substantial decision, and the right answer depends entirely on your specific flue, your crown, and your roofline. We’d rather inspect first and tell you honestly whether you’re looking at a repair or a rebuild than quote a number over the phone and adjust it later. Our technicians have up to 15 years of experience, we’re licensed and insured, and we work with the product lines that hold up: DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield.
Call (855) 340-2065 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Clean, inspect, and repair in a single visit – your flue, your dryer vent, your safety, all handled on one call.
Pricing reflects the Provo market as of 2026. Chimney Sweep Provo offers free estimates – call (855) 340-2065.
Written by the team at Chimney Sweep Provo.
What Our Customers Say
"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Elena Guzman"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
- Rachel Ziegler"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
- Emily Wong